Description
SEGWAY PT battery plug protection set for base
The SEGWAY PT battery plug protection set for Base protects your device against rising damp and the ingress of dust and creepy-crawlies during storage.
Especially in winter, the SEGWAY PT is very often not needed and then the question arises:
Where to put the device and HOW TO STORE BATTERIES CORRECTLY?
The manufacturer specifies a minimum temperature for storage.
Many people do not know that the newer version (SE) in particular, depending on the revision, also stops charging below 15°C (the 2 green LEDs light up but charging does not take place here) and the batteries, depending on the revision, no longer allow charging below 3°C either.
You don’t have such a space available? It is then necessary to remove the batteries and store them separately. This is also possible for at least 3 months without recharging the batteries.
When the battery is removed, the device is open at the bottom via the battery plugs on the main circuit boards and is very sensitive to rising damp, dust, dirt and insects.
With the SEGWAY PT battery plug protection set for Base, you can now store the device in the cellar, garage or garden shed without any worries.
Instructions:
You simply place your device on its left or right side. Use a 3mm Allen key to remove the 4 screws from each battery and carefully remove them. Then place the seal from the SEGWAY PT battery plug protection set on the plug, fit the cover and tighten the screws supplied. Before tightening, simply center the seal again and you’re done.
Caution: As with the assembly, you should only tighten the screws lightly with a torque of 1.6 Nm.
The removed batteries can be sent to us for the annual performance test/calibration.
Color: grey/black
Set for one device consisting of:
– 2 battery seals (which are included)
– 2 cover housings for plugs
– 4 stainless steel screws
If you would like to send your device in for servicing or have it picked up, simply contact us!
